The Audit system is based on weightings, that operate in a hierarchy:
Global Weightings for Criteria
can be overridden by...Workspace Weightings for Criteria
can be overridden by...Project Weightings for Criteria
Defining Workspace Weightings
Navigate to Auditing -> Audit Weightings for Workspace
Create a new Record and ensure that you set Audit Category and Weighting
Defining Project Weighting Overrides
Navigate to Auditing -> Audit Weightings for Project
Create a new Record and ensure that you set Audit Category and Weighting
Using BIM Protocols
You can specify the following BIM protocols that will affect the Model Audit dashboard:
Check Level Elevation Only (ignoring the level name in auditing). Also referred to as "Use Simplified Elevation" on the dashboard.
Acceptable value is: "Yes"
Grid Intersection Rounding (number of decimal points)
Grid Intersection Rounding
Enter number of digits to which you want to round. A negative value rounds digits to the left of the decimal point; a value of zero rounds to the nearest integer.
-1 = round to nearest 10mm
0 = round to nearest whole number
1 = round to 1 decimal point
Setting up Filename Checking
Refer to this article for more detail on the Filename Auditing module.
Filename Checking can be configured directly in DS Command.
Use the BIM Wizard
Access the "Filenames" configuration page
Set your delimiting character
Set the number of Parts
Save the Record
Then you can begin customising the individual Parts of filenames.